Mounting a dynamic 3TB harddisk in W7 64bit
Posted: 23 May 2013, 10:49
Hi,
I have two 3TB harddisks in a W7 pc.
I have copied more than 2TB onto one disk and Windows ignores this disk. It will be indicated in System as failed.
After using Testdisk it will be shown as follows: My goal is to be able to see the 2 TB Data in Windows once again.
Could you help me how to change the partition table to have success?
Thank you very much for your help.
Kind regards,
I.
I have two 3TB harddisks in a W7 pc.
I have copied more than 2TB onto one disk and Windows ignores this disk. It will be indicated in System as failed.
After using Testdisk it will be shown as follows: My goal is to be able to see the 2 TB Data in Windows once again.
Could you help me how to change the partition table to have success?
Thank you very much for your help.
Kind regards,
I.