Hi,
I have two 3TB harddisks in a W7 pc.
I have copied more than 2TB onto one disk and Windows ignores this disk. It will be indicated in System as failed.
After using Testdisk it will be shown as follows:
My goal is to be able to see the 2 TB Data in Windows once again.
Could you help me how to change the partition table to have success?
Thank you very much for your help.
Kind regards,
I.
Mounting a dynamic 3TB harddisk in W7 64bit
Forum rules
When asking for technical support:
- Search for posts on the same topic before posting a new question.
- Give clear, specific information in the title of your post.
- Include as many details as you can, MOST POSTS WILL GET ONLY ONE OR TWO ANSWERS.
- Post a follow up with a "Thank you" or "This worked!"
- When you learn something, use that knowledge to HELP ANOTHER USER LATER.
Before posting, please read https://www.cgsecurity.org/testdisk.pdf
When asking for technical support:
- Search for posts on the same topic before posting a new question.
- Give clear, specific information in the title of your post.
- Include as many details as you can, MOST POSTS WILL GET ONLY ONE OR TWO ANSWERS.
- Post a follow up with a "Thank you" or "This worked!"
- When you learn something, use that knowledge to HELP ANOTHER USER LATER.
Before posting, please read https://www.cgsecurity.org/testdisk.pdf