Page 1 of 1

Mounting a dynamic 3TB harddisk in W7 64bit

Posted: 23 May 2013, 10:49
by testdiskisti
Hi,

I have two 3TB harddisks in a W7 pc.

I have copied more than 2TB onto one disk and Windows ignores this disk. It will be indicated in System as failed.

After using Testdisk it will be shown as follows:
testdisk_1.JPG
testdisk_1.JPG (46.73 KiB) Viewed 873 times
My goal is to be able to see the 2 TB Data in Windows once again.

Could you help me how to change the partition table to have success?

Thank you very much for your help.

Kind regards,

I.