Page 1 of 1
Photorec stopped. How do I Resume the Photorec Session?
Posted: 18 Nov 2019, 07:38
by mkerdman
Photorec stopped in the middle of a File Recovery Session.
The Estimated Time to completion is 16h4m55.
The Elapsed Time is not counting/moving.
The Cursor is blinking on Stop.
How do I Resume the Photorec Session?
Thank you in advance.
Re: Photorec stopped. How do I Resume the Photorec Session?
Posted: 18 Nov 2019, 17:12
by recuperation
Maybe your target drive is full.
Re: Photorec stopped. How do I Resume the Photorec Session?
Posted: 18 Nov 2019, 18:03
by mkerdman
Nope, not even close.
It's a new 5TB USB 3.0 Drive with 4.49TB Available.
Should I code the CMD Window running Photorec?
Re: Photorec stopped. How do I Resume the Photorec Session?
Posted: 18 Nov 2019, 18:32
by recuperation
mkerdman wrote: ↑18 Nov 2019, 18:03
Should I code the CMD Window running Photorec?
No, you don't have to code any software. Photorec is working.
Check the SMART status of your hard drive using smartmontools with the -a parameter.
Post the log.
Re: Photorec stopped. How do I Resume the Photorec Session?
Posted: 18 Nov 2019, 19:58
by mkerdman
Attached is my Photorec Screen which has not chnaged in any way over the last 12 hours.
EDIT: I cannot seem to attach a .jpg.
Maybe it's because I am new to the board.
Re: Photorec stopped. How do I Resume the Photorec Session?
Posted: 18 Nov 2019, 22:47
by recuperation
hover above the third symbol to the right