PLEASE HELP Raid 0 Array lost!

How to use TestDisk to recover lost partition
Post Reply
Message
Author
Iceking007
Posts: 15
Joined: 30 Nov 2012, 19:09

PLEASE HELP Raid 0 Array lost!

#1 Post by Iceking007 » 30 Nov 2012, 19:16

My system updated bios and when it restarted I got the failed Raid array when booting one of the array disks was not showing as part of the array.

I am trying to recover four 1TB Raid 0 drives created through intel's on board driver through boot tool; I fallowed the instructions deleting the Raid array and adding a new one with the same specs; the harddrives were not moved or disconnected so the same order should have been kept.

Using Testdisk I can scan successfully although sometimes taking a full day for deep scan but it says unable to recover size is too small. Please help me on what I am doing here; thank you so much.

My last backup was over a month ago so there is very important data That I require and cannot duplicate!!
Quick Search.jpg
This is a screen shot after a quick search of the array
Quick Search.jpg (73.6 KiB) Viewed 861 times
Test Disk Scan.jpg
This is nearing the end of a deep search
Test Disk Scan.jpg (80.84 KiB) Viewed 861 times
After Deep Scan.jpg
This screen shot is fallowing a deep search
After Deep Scan.jpg (75.46 KiB) Viewed 861 times

Sponsored links

Iceking007
Posts: 15
Joined: 30 Nov 2012, 19:09

Re: PLEASE HELP Raid 0 Array lost!

#2 Post by Iceking007 » 02 Dec 2012, 19:46

This screen shot is of a scan I did with Acronis Recovery Expert through Disk Director 2011 It only shows my D: drive not my H: drive partition on the same array so I don't think I should use it also I'm not sure which D: drive would be correct since it list it twice and there is no way to browse the files.

Acronis Recovery Expert Scan.jpg
Acronis Recovery Expert Scan.jpg (75.57 KiB) Viewed 860 times


PLEASE HELP ME I'M DESPERATE!!!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest