missing files after partition recovery
Posted: 28 Jan 2020, 08:13
Hi there,
is unfortunately a lot of text, but serves for a better description.
https://4kpornindex.com/
I had a reading problem yesterday when booting up Win10 on one of the two hard drives (= data disk, partitioned into 3 parts). In any case, the automatic correction of H: started after 8 seconds. After that, the percentage is up to 9% very quickly and then persists for 4 hours at 9%.
After rebooting again, I started the repair sequence again (same result) and then skipped the repair again. In Windows, I: and J: (Partition 2 / Partition 3) were displayed correctly and H: (= Partition1) could not be accessed / read or was displayed as "System H:" (previously "Backup1").
Under management, the disk was shown as error-free and RAW instead of NTFS.
Then I ran the test disk and the first partition was displayed with "* HPFS NTFS" (this hard disk is not a boot disk), continued to "Deeper Search" for 3-4 hours and at 70% when it arrived at the third partition I did canceled.
According to the instructions, then tries to see the file system on partition 1 -> Can't open filesystem
After this did not work but the partition was there, I continued on "Write" with yes and rebooted.
After the reboot, the Windows repair procedure again (this time up to 100%) Now he can no longer find any bad files on partition 1 (only about 10% are here)
In Testdisk he can now also display the file system, but dues is identical to Win10
It would be nice if someone could give me a tip on how best to get my files back
is unfortunately a lot of text, but serves for a better description.
https://4kpornindex.com/
I had a reading problem yesterday when booting up Win10 on one of the two hard drives (= data disk, partitioned into 3 parts). In any case, the automatic correction of H: started after 8 seconds. After that, the percentage is up to 9% very quickly and then persists for 4 hours at 9%.
After rebooting again, I started the repair sequence again (same result) and then skipped the repair again. In Windows, I: and J: (Partition 2 / Partition 3) were displayed correctly and H: (= Partition1) could not be accessed / read or was displayed as "System H:" (previously "Backup1").
Under management, the disk was shown as error-free and RAW instead of NTFS.
Then I ran the test disk and the first partition was displayed with "* HPFS NTFS" (this hard disk is not a boot disk), continued to "Deeper Search" for 3-4 hours and at 70% when it arrived at the third partition I did canceled.
According to the instructions, then tries to see the file system on partition 1 -> Can't open filesystem
After this did not work but the partition was there, I continued on "Write" with yes and rebooted.
After the reboot, the Windows repair procedure again (this time up to 100%) Now he can no longer find any bad files on partition 1 (only about 10% are here)
In Testdisk he can now also display the file system, but dues is identical to Win10
It would be nice if someone could give me a tip on how best to get my files back