I'm wondering if I should stop the process and start again. Is it possible to get better performance by modifying the initial parameters?
In addition, I have some questions about the current process.
The first few lines of the output at the moment are:
Code: Select all
PhotoRec 7.2-WIP, Data Recovery Utility, July 2019 Christophe GRENIER <email@example.com> https://www.cgsecurity.org Disk /dev/rdisk3 - 123 GB / 114 GiB (RO) Partition Start End Size in sectors 1 * HFS 32 0 1 240254975 0 1 240254944 Destination /Volumes/Seagate Backup Plus Drive/space_bak/recup_dir Pass 1 - Reading sector 71756960/240254944, 21104300 files found Elapsed time 73h33m10s - Estimated time to completion 172h42m53
- The line beginning with "Pass 1 - Reading sector" has two numbers "71756960/240254944". The number 71756960, which I assume is the current sector, has not changed, although the number of files found climbs steadily.
- The estimated time to completion increases approximately 2 seconds for each second that the program has been running.